4
Operating manual TROX TNC-EASYCONTROL
2
Safety and correct use
General information regarding safety
Only specialist personnel are allowed to perform the
described work on TNC-EASYCONTROL.
Only skilled qualified electricians are allowed to work on the
electrical system.
Be sure to observe the code of good practice and especially
safety and accident prevention regulations for all work on
TNC-EASYCONTROL and on fire dampers.
In particular:
• National laws regarding the safety of devices and
products, industrial health and safety regulations, and
accident prevention regulations
• General regulations (VGB1) of the Accident Prevention
Regulations for Electrical Installations and Equipment
(Unfallverhütungsvorschriften für elektrische Anlagen und
Betriebsmittel (BGV A2))
General safety measures
• General safety measures
Incorrect use
• Do not use the controller for areas of application that are
not described in this manual.
• Do not use the controller outdoors, in wet areas, or in
potentially explosive atmospheres.
Residual risks
Danger of electric shock! Do not touch any live components!
Electrical equipment carries a dangerous electrical voltage.
• Only skilled qualified electricians are allowed to work on
the electrical system.
• Before you work on the controller, switch off the voltage
supply and secure it against being switched on again.
• Only then should you work on TNC-EASYCONTROL.
Caution
If TNC-EASYCONTROL has been kept in an
unheated area, wait for two hours before switching
on the supply voltage. Condensation may damage
the electronic components beyond repair. Only after
about 2 hours will the system have reached room
temperature.
• Exercise caution when installing the unit
Caution
Foreign objects or liquids may get into the casing
and result in injuries to your hands.
Always wear protective gloves.
If objects or liquids get into the casing, or if the device emits
a smell or smoke, have it checked by the manufacturer.
Correct use
TNC-EASYCONTROL is used to safely control and monitor
TROX fire dampers.
• Use the controller only for the applications described in
this manual.
• The controller must only be used within the limits specified
in the technical data.