EN
6
Operating manual – turbo fan TFV 10 / TFV 20 / TFV 30
Assembly and start-up
Scope of delivery
•
1 x Device
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Connecting the (optional) hose distributors
The devices
TFV 20
/
TFV 30
can be connected to optional hose
distributors in order to direct the air current towards different
locations.
The device
TFV 20
can be used with an optional two-way hose
distributor, and the device
TFV 30
with an optional three-way
hose distributor.
Info
Seal off unused connections by means of suitable
sealing caps and possibly with hose clamps to prevent
a decrease in the air flow rate.
Info
The procedure of fitting a hose distributor is described
below using the example of a three-way hose
distributor that is connected to the TFV 30; however, it
applies accordingly to the TFV 20 and a two-way hose
distributor.
1. Open the clamps of the three-way hose distributor.
2. Affix the three-way hose distributor at the designated
locations at both ends of the air outlet.
3. Make sure that at the bottom the three-way hose
distributor is positioned flush with the device.
4. Close both clamps of the three-way hose distributor.
5. Check the clamps and the three-way hose distributor for
tight fit.
6. If attached, remove the sealing caps from the three-way
hose distributor.
