EN
3
insulation drying unit Qube+
Intended use
The Qube+ is to be used in low pressure mode for insulation
drying of floating screeds, flat roofs (warm roof constructions)
and hollow floorings. It is intended to transport non-aggressive
and non-explosive gaseous media.
Improper use
The device is not suitable for the inflation of bouncy castles or
similar objects.
The device is not designed to suck in large quantities of water.
If, during insulation drying, you notice that there are large
amounts of water left in the insulation layer, the water must be
sucked off with a water extractor before using the device.
The device is not suitable for the intake of frothing or foaming
media, aggressive cleaning agents and acetone-based fluids.
Media other than those listed as intended use must not be
conveyed.
Personnel qualifications
People who use this device must:
•
be aware of the dangers that occur when working with
electric devices in damp areas.
•
have read and understood the instructions, especially the
Safety chapter.
Residual risks
Warning of electrical voltage
Work on the electrical components must only be
carried out by an authorised specialist company!
Warning of electrical voltage
Before any work on the device, remove the mains plug
from the mains socket!
Hold onto the mains plug while pulling the power cable
out of the mains socket.
Warning of hot surface
Risk of injury due to hot surfaces at the outlet opening.
Warning
Small objects and particles can be sucked in and lead
to injuries.
Make sure that no person is standing near the inlet or
outlet opening while the device is running.
Warning
Dangers can occur at the device when it is used by
untrained people in an unprofessional or improper way!
Observe the personnel qualifications!
Warning
Risk of suffocation!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.
Note
Do not operate the device without an inserted air filter!
Without the air filter, the inside of the device will be
heavily contaminated. This could reduce the
performance and result in damage to the device.
Note
Overheating of motor electronics
Permanent or repeated overheating may destroy the
motor electronics. Avoid overheating the device and
provide sufficient air circulation. If necessary, direct the
warm air out of the room. Room temperatures above
35 °C are to be avoided during operation.
Also observe the information in the Set-up chapter.
Note
Observe the overvoltage protection.
The device comes equipped with an overvoltage
protection. When checking for electrical safety, please
bear in mind that the test voltage has to be reduced to
250 V.
Note
Damage to the turbine due to sucked-in particles.
If impurities enter into the turbine, this might damage
the turbine. The turbines are suited for transporting
clean air only.
Behaviour in the event of an emergency
1. Switch off the device.
2. In an emergency, disconnect the device from the mains
feed-in: Hold onto the mains plug while pulling the power
cable out of the mains socket.
3. Do not reconnect a defective device to the mains.
