EN
9
spot cooling air conditioning unit PT 2700 SP
Extending the hot air duct (optional)
Note
Connected ducts must not exceed a length of 3 m.
1. Cut the air duct to size or shorten or extend it as required.
ð
The diameter of the duct to be extended must
be 200 mm.
2. Place the duct to be extended on the other duct while
performing a rotating movement to the right.
3. Wrap sturdy tape around the point where the ducts
intersect.
Inserting the air filter
Note
Do not operate the device without an inserted air filter!
Without the air filter, the inside of the device will be
heavily contaminated. This could reduce the
performance and result in damage to the device.
Make sure that the air filter is installed before switching the
device on.
1. If the air filter (
8
) has not already been inserted, push the
air filter (
8
) into the designated recess.
8
Installation
Note
The opening of the hot air duct in the outdoor area
should be positioned so that it is rainproof and
preventing any backflow, or so that it is bent towards
the bottom.
The cold air duct (
1
) must be directed towards the point or area
to be cooled (see chapter Operation).
The hot air duct (
1
) must be placed in the outdoor area so that
the warm exhaust air can be directed outside.
Indoors
Machine
Outdoors
Hot Air Extraction
1
9