6
EN
spot cooling air conditioning unit PT 2700 SP
Device depiction
2
3
4
9
1
8
6
7
5
No. Designation
1
Hot air duct
2
Transport handle
3
Condensation tank
4
Wheels with parking brake
5
Function selector switch
6
Cable storage compartment with power cable
7
Condensation hose connection
8
Air inlet with air filter
9
Cold air duct
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Please note that additional transport regulations might apply to
devices containing flammable refrigerants. The equipment's
arrangement and the maximum number of components to be
transported together can be gathered from the applicable
transport regulations.
To make the device easier to transport, it is fitted with wheels.
To make the device easier to transport, it is fitted with a carry
handle.
Before
transporting the device, observe the following:
• Switch the device off.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
• Drain the remaining condensate from the device.
• Do not use the power cable to drag the device.
• Only wheel the device on a level and smooth surface.
While
transporting the device, observe the following:
• Only transport the device in an upright position.
After
transporting the device, proceed as follows:
• Set up the device in an upright position after transport.
• Apply and lock the brakes at the wheels again.
Storage
Before
storing the device, proceed as follows:
• Clean the condensation tank and/or the condensation drain
hose if necessary (see chapter Maintenance).
• Drain the remaining condensate from the device.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
When the device is not being used, observe the following
storage conditions:
• Only store the device in a room measuring more than
15 m
2
.
• Only position the device in rooms where there is no source
of ignition (e.g. open flames, an active gas appliance or an
electric heater).
• Store the device in a dry location and protected from frost
and heat.
• Store the device in an upright position where it is protected
from dust and direct sunlight.