EN
7
spot cooling air conditioning unit PT 2700 SP
• If required, use a cover to protect the device from invasive
dust.
• Place no further devices or objects on top of the device to
prevent it from being damaged.
Assembly and start-up
Scope of delivery
• 1 x Device
• 1 x Cold air duct
• 1 x Flue pipe
• 1 x Air filter
• 1 x Condensation tank
• 1 x Hot air duct
• 1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Start-up
When positioning the device, observe the minimum distance
from walls or other objects as described in the Technical data
chapter.
A
B
C
C
D
• Only position the device in rooms where potentially leaking
refrigerant cannot accumulate.
• Only position the device in rooms where there is no source
of ignition (e.g. open flames, an active gas appliance or an
electric heater).
• Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
• Only put up the device in an upright, stable position on firm
ground.
• Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
• Make sure that extension cables are completely unrolled.
• Keep air inlets and outlets as well as the exhaust air hose
connection free.
• Make sure that no curtains or other objects interfere with
the air flow.
Inserting the condensation tank
Note
Condensate is formed during operation and must be
collected with the condensation tank.
Before commissioning, make sure that the
condensation tank is correctly inserted. Place the
opening of the condensation tank underneath the
condensate outlet inside the device (see figure).
Operating the device with a condensation drain hose is
also possible.
3