A - 7
EN
Operating manual for LD6000 PTS
07 Troubleshooting
Fault description
Potential causes
Proposed solution
LD6000 PTS does not connect via
Bluetooth using the headphones/
Bluetooth receiver/ speaker
(optionally available) .
The other end is not switched on .
Switch on the other end .
The other end was paired with a different
device .
Refresh the pairing mode (search
mode) between LD6000 PTS and
headphones/ Bluetooth receiver/
speaker .
Pairing (search mode) was not performed
correctly .
Devices cannot locate each other
when in pairing mode (search
mode) .
One of the devices to be paired is not in
pairing mode (search mode) .
Switch both devices into pairing
mode (search mode) and wait for a
few seconds until their connection is
established .
The devices are installed too far apart to
connect (maximum reach 10 m) .
Bring the devices as close as possible
to one another during pairing mode
(search mode) .
Level indication at the LD6000
PTS starts to flash in pairing mode
(search mode) .
Fault during pairing mode (search mode)
Switch off the LD6000 PTS and
perform pairing (search mode) once
again .
Connection is suddenly lost during
operation .
Headphones/ Bluetooth receiver or
speaker positioned too far away from the
LD6000 PTS (maximum reach 10 m) .
Bring the devices back into the
transmission range .
Batteries of the LD6000 PTS/
headphones/ Bluetooth receiver or
speaker (optionally available) are too low .
Change the battery of the LD6000
PTS or charge headphones/ Bluetooth
receiver/ speaker .
LD6000 PTS/ headphones/ Bluetooth
receiver or speaker have switched off for
no reason .
Switch the device back on .
LD6000 PTS can no longer be
switched on / off .
Software bug
Briefly disconnect the battery of the
LD6000 PTS Bluetooth transmitter
and then reconnect it .
Connection between LD6000
PTS and headphones/ Bluetooth
receiver/ speaker (optionally
available) is established correctly,
but no sound can be heard .
The
"
mute
"
function (muting) at the
LD6000 PTS is active .
Briefly press the Multi-function button
(MUTE LED should be illuminated) .
Fibre optic cable was damaged or is
visibly kinked (cable break) .
Return the device to the manufacturer
for repair/inspection .
Sensor head was damaged or torn off .
Locating of the fibre optic cable /
probe head is not possible .
The frequency generator is not properly
connected to the LD6000 PTS .
Connect the frequency generator
according to this manual .
The pipe is located too deep in the
ground or underneath a sealed surface
with metal .
Unfortunately it is not possible to
carry out detection here!
Fibre optic cable is damaged or broken .
Return the device to the manufacturer
for repair/inspection .
