6
EN
radiant heater IR 1200 S
Assembly and start-up
Scope of delivery
•
1 x device
•
4 x Wall plug for wall holder
•
4 x Fastening screw
•
1 x manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Warning of electrical voltage
Risk of injury due to incorrect assembly!
Local or national regulations may apply for installation..
We recommend to have the installation carried out by a
qualified electrician.
The device is only suited for wall mounting. Observe the
following requirement for installation inside a room:
Warning
Risk of fire due to improper installation!
There is a risk of fire if the required minimum
distances are not observed.
Observe the “Installation” section in the “Assembly and
start-up” chapter and the technical data in the
“Technical annex” chapter.
Installation
When installing the device, observe the minimum distances
from walls and other objects as described in the Technical data
chapter.
•
Minimum distance of 200 cm from the floor.
•
Minimum distance of 50 cm from adjacent walls or other
objects.
•
Do not install the device at the ceiling or directly behind a
door.
•
Never install the device in a way that it radiates directly
onto walls or other objects. Observe the minimum
distances from walls or other objects according to the
Technical data chapter.
•
Only install the device in a horizontal position.
0
A
B
B
D
00
00
C
The following is required for installation:
•
a pencil for marking the drill holes
•
a tape measure for determining the distances
•
a suitable drill
•
wall plugs appropriate for the structure of the wall
•
a screwdriver
•
a spirit level
1. Mark the drill holes on the wall according to the following
pattern:
79 mm
67 mm
2. Drill the holes into the wall at the marked positions.
3. Insert suitable wall plugs into the drill holes.
