6
EN
Fog and flue gas simulator FS 200
1. Remove the safety bolt (20).
2. Fold the holder's stabiliser (21) in until it is located at the
same height as the lower holder (22).
3. Fold down the upper holder (23) until it abuts the housing.
24
20
22
4. Fold up the lower holder (22) until it abuts the housing as
well.
5. Then put the safety bolt (20) back to fix the holder in place.
6. Wind the power cable up on the foot (24).
Storage
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
protected from dust and direct sunlight
•
with a plastic cover to protect it from invasive dust, if
necessary
•
The storage temperature is the same as the range given in
the Technical data chapter.
•
The ground is protected against possibly dripping fluid
residues.
Operation
Positioning
The location for the fog generator has to meet the following
requirements:
•
sufficiently dimensioned
•
solid, incombustible ground insensitive to heat
•
vibration-free
•
minimum distance of 2 m to combustible or heat-sensitive
objects
•
sufficient supply of fresh air
Information
regarding the operation with emergency power
units
•
The applied emergency power generators must be
asynchronous, feature a nominal capacity of min. 4 kVA
(230 V) and be checked for proper functioning.
•
Before connecting the fog generator, the emergency power
unit must be brought to operating temperature while
unloaded (depending on the device approx. 1 to 2 min).
Only after this is completed can failure-free operation be
guaranteed.
Information
regarding the use of extension cables:
•
Ensure a high quality of the cable.
•
The cable's cross-section should amount to at least
2.5 mm².
•
All extension cables must have been rolled off completely.
Folding holder out
Folding the holder out works just as folding it up, only in reverse
order (see "Folding the holder up" ).
Connecting the fog transport hose
1. Connect one end of the fog transport hose to the
connection coupling at the device.
2. Connect the other end of the fog transport hose with the
object to be tested.
