EN
7
sound level measuring device controlled via smartphone BS30WP
Continuous measurement
Info
Note that moving from a cold area to a warm area can
lead to condensation forming on the device's circuit
board. This physical and unavoidable effect can falsify
the measurement. In this case, the app will either
display incorrect measured values or none at all. Wait a
few minutes until the device has become adjusted to
the changed conditions before carrying out a
measurement.
When the appSensor has been successfully connected to the
terminal device, a continuous measurement is started and
indicated. The refresh rate is 1 second. The 12 most recently
measured values are displayed graphically (9) in chronological
sequence. The currently determined and calculated measured
values are displayed numerically (10).
SENSORS
MEASUREMENTS
REPORTS
CUSTOMERS
SETTINGS
9
10
11
BS30WP
Sound level
[45,3 | 64,9] Ø 56,8
64,9 dbA
No. Designation
Meaning
9
Graphic display
Indicates the sound level as measured
over the course of time.
10 Numeric display
Indicates the minimum, maximum and
average values for the sound level as
well as the current value.
11
Menu
button
Opens the menu to adjust the settings
of the current measurement.
Info
The indicated measured values will not be saved
automatically.
Info
By tapping on the graphic display (9) you can switch
over to the numeric display and vice versa.
Measurement settings
Proceed as follows to adjust the settings for the measurement:
1. Press the
Menu
button (11) or the free area below the
measured value display.
ð
The context menu opens.
2. Adjust the settings as required.
12
13
14
15
16
SENSORS
MEASUREMENTS
REPORTS
CUSTOMERS
SETTINGS
Reset min / max / Ø
X/T measurement
Disconnect sensor
Sensor settings
Start recording
BS30WP
Sound level
[45,3 | 64,9] Ø 56,8
64,9 dbA
No. Designation
Meaning
12
Reset min / max / Ø
button
Deletes the determined values.
13
X/T measurement
button
Switches between continuous
measurement and individual
measurement.
14
Disconnect sensor
button
Disconnects the connected
appSensor from the terminal
device.
15
Sensor settings
button
Opens the settings menu for the
connected appSensor.
16
Start recording
button Starts a recording of the determined
measured values for later
evaluation.
