EN
15
pyrometer controlled via smartphone BP21WP
appSensor settings
Proceed as follows to adjust the settings for the appSensor:
1. Press the
Sensors
button (6).
ð
A list of connected and available sensors will be
displayed.
2. Select the line with the appSensor the settings of which
you want do adjust and swipe right at the yellow marking.
3. Confirm your input.
ð
The sensor menu opens.
4. Alternatively, you can press the
Sensors
button (6).
5. Press the
Menu
button (11).
ð
The context menu opens.
6. Press the
Sensor settings
button (15).
ð
The sensor menu opens.
Disconnecting an appSensor
Proceed as follows to disconnect an appSensor from the
terminal device:
1. Press the
SENSORS
button (6).
ð
A list of connected and available sensors will be
displayed.
2. Select the line with the appSensor to be disconnected and
swipe left at the red marking.
3. Confirm your input.
ð
The appSensor is now disconnected from the terminal
device and can be switched off.
4. Alternatively, you can press the
Menu
button (11).
ð
The context menu opens.
5. Press the
Disconnect sensor
button (14).
6. Confirm your input.
ð
The appSensor is now disconnected from the terminal
device and can be switched off.
Switching off an appSensor
Info
Always terminate the connection between appSensor
and app before you switch off the appSensor.
Proceed as follows to switch off an appSensor:
1. Press and hold the
On / off / measurement
button (3) for
approx. 3 seconds.
ð
The LED (2) on the appSensor goes out.
ð
The appSensor is switched off.
2. You may now exit the Trotec MultiMeasure Mobile app on
the terminal device.
Maintenance and repair
Battery change
A battery change is required when the LED at the device flashes
red or the device can no longer be switched on. See chapter
Operation.
Cleaning
Clean the device with a soft, damp and lint-free cloth. Make
sure that no moisture enters the housing. Do not use any
sprays, solvents, alcohol-based cleaning agents or abrasive
cleaners, but only clean water to moisten the cloth.
Repair
Do not modify the device or install any spare parts. For repairs
or device testing, contact the manufacturer.
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Bluetooth connection is terminated or interrupted
•
Check whether the LED at the appSensor flashes green.
If so, briefly switch it off completely, then turn it back on.
Establish a new connection to the terminal device.
•
Check the battery voltage and insert new or freshly
charged batteries, if required.
•
Does the distance between appSensor and terminal device
exceed the appSensor's radio range (see chapter
Technical
data
) or are there any solid building parts (walls, pillars
etc.) situated between appSensor and terminal device?
Shorten the distance between the two devices and ensure
a direct line of sight.
The sensor cannot be connected to the terminal device
although it is displayed there.
•
Check the Bluetooth settings of your terminal device.
A possible reason for this could be special, manufacturer-
specific settings relating to an improved location accuracy.
Enable these settings, then try to establish a connection to
the sensor again.
Further information and assistance regarding the used sensor
type will be provided in the MultiMeasure Mobile app via the
menu item Settings =>
Help
. Selecting the menu item
Help
opens a link to the app's help page. You can open a drop-down
menu with numerous support entries from the
Table of
contents
. Optionally, you can also scroll through the entire help
page and thoroughly acquaint yourself with the individual help
topics.
