Trotec 1.410.000.203, Руководство по эксплуатации

Страница: 14 / 83

Operating manual – Electric heater TEH 20 T / 30 T EN B-3
8. Installation conditions
When choosing the installation location of the electric heater, a num-
ber of spatial and technical conditions must be taken into account. Any
non-compliance may impair the functionality of the device and/or of its
accessories or result in hazardous situations for persons and property.
The following points are to be observed during installation:
The device must be installed in a stable position and placed on
a fireproof, horizontal, even and vibration-free surface.
The installation location must be dry. It must be ensured that
no humidity (e. g. spray water, rain or snow) can penetrate the
device. If humidity gets inside the electric heater nevertheless,
disconnect the device from the power supply and have it checked
by a certified specialist workshop.
The device must be connected to a properly protected socket
complying with all parameter requirements (refer to "Technical
data").
The electric heater must not be operated in extremely dusty
environments.
The minimum distance of the device to inflammable materials
must be at least 2 m.
The minimum distance to walls must be at least 50 cm.
Air humidity at the installation location must not condense on
the device.
Intake and exhaust openings must not be covered.
9. Description of device
The electric heater TEH 20 T or 30 T includes the following components:
Device overview
1
2
3
4
5
6
7
8
9
10
1 Exhaust opening 6 Turn control
2 Housing 7 Indicator lamp
3 Handle 8 Power switch
4 Intake opening 9 Power connection
5 Fan 10 Feet
10. Functions and operation
1
2
3
Switching on the electric heater
Switch the electric heater on by setting the power switch (1) to position
"1". The power switch will flash green and the fan is activated.
Switching off the electric heater
Switch the device off by setting the power switch (1) to position "0".
Caution!
Damage to the device due to overheating.
Do not switch off the device by pulling out the power
cord. This may cause the device to overheat.
Switch off the device properly. Do not disconnect the
power plug before the fan motor has come to a complete
standstill.
Setting the temperature
The temperature of the electric heater can be set by turning the turn
control (3) of the thermostat (on the back of the device) to the desired
position (refer to chapter "Description of device"). The red indicator lamp
(2) starts to flash when the heating process begins.