User Manual Qiwi Lite
Support: www.tronteq.de/support
Release 11/2016
Seite 14 von 31
Auto-Negotiation will negotiate the highest speed possible that is supported by the destination device.
In case that Auto-Negotiation is not used, the configuration for speed and duplex must be done in both
network participants to enable communication.
If you set the speed or the duplex mode to "auto", both values are set to
"auto".
Changes can be made by clicking the “Apply” button. To get the actual settings from the switch click
the “undo” button.
Deactivating of administration ports is not possible due to security reason.
Therefore the port must be deactivated as admin port.
With QoS (Quality of Service” the data traffic is prioritized in a network. The switch supports two
different procedures.
Ports based QoS can be activated on maximum 4 ports. For the frame
based QoS there is no such limitless.
6.2.
Port Mirroring
Port mirroring (or port monitoring) makes it possible to duplicate network traffic to an observation port
and to analyze it there. Per port, the incoming and outgoing traffic can be duplicated independently.
The settings for port mirroring are set in the web interface at
Configuration > Port Mirroring
.
In the left table the port mirroring feature is activated or deactivated (default: deactivated). Also, the
observation port (destination port) is set.
The table on the right side defines which ports and traffic, incoming/outgoing, should be mirrored to
the destination port.
To confirm the settings click on the “set” button.
