![Tronic KH 3106 Скачать руководство пользователя страница 50](http://html.mh-extra.com/html/tronic/kh-3106/kh-3106_operating-and-safety-instructions-manual_1171249050.webp)
Caution!.
You will
first
have
to
recharge
the battery if the
red LED
“Empty”
is illuminated. Otherwise
the battery will be depleted, usually
resulting in a considerable loss of
charging capacity.
b) Removing the device
If you wish to terminate the power sup-
ply for your device from the energy sta-
tion, you should first ...
•
switch off the device ...
•
and also set the
main switch
on
the energy station to “
OFF”
(centre
position).
In this way you will prevent that current
is still flowing while the plug is being
pulled. Sensitive devices may malfunc-
tion as a consequence.
•
You can now pull the connectors
from both the device and the ener-
gy station.
6. If it fails to work...?
If none of the two
LEDs
light up after
switching on, one of the fuses on the
energy station might have blown.
Changing the fuses
is described in
more detail in
Chapter 8
.
Should an LED light up on the energy
station after switching on but your
device
fail to work, you should
imme-
diately switch off
the energy station.
In this case, initially check whether the
cable is correctly connected – and
“Positive“ and “Negative“ have not
been switched. If required, also check
the fuse in your device as described in
its instructions.
51
a) Connecting the device
Caution! Before connecting your
device to the energy station,
you
must first ensure that
“Positive”
and
“Negative” are not switched.
Otherwise your device could be damaged.
With the supplied cable the
device
connector
is connected so that
Positive
is on the
inside
and
Negative
on the
outside
, as
shown. You can
- use
this cable if the jack on your
device is marked thus:
- not use
this cable if the jack on
your device is marked thus:
On devices with
permanently con-
nected
cable with motor vehicle con-
nector, “Positive” and “Negative“ have
the
correct polarity
.
Insert the
device connector
of the
supplied cable in the jack on your
device.
Insert the
motor vehicle connector
...
... in the
motor vehicle socket
on
the energy station.
Once you have connected your device
to the energy station ...
you can now set the
main switch
to
“ON”
– your device will now be
supplied with power
A
green LED “Full”
will be illumi-
nated as soon as the main switch is
switched on and sufficient energy is
available.
A
red LED “Empty”
will be illumi-
nated as soon as the main switch is
switched on – but the battery is
almost empty.
RZ_KH3106_Energiestation.qxd4 07.11.2003 9:27 Uhr Seite 51