Trojan IGNITE 360, Руководство пользователя

Страница: 22 / 25

22
tension, you must also make a tracking adjustment to compensate for the change in belt tension.
DO NOT OVERTIGHTEN – Over tightening will cause belt damage and premature bearing failure.
BELT TRACKING ADJUSTMENT
This Trojan Ignite 360 Treadmill is designed to keep the belt reasonably centred while in use. It is normal for
some belts to drift near 1 side while the belt is running with no one on it. After a few minutes of use, the belt
should have a tendency to centre itself. If during use, the belt continues to move toward 1 side, adjustments
are necessary.
The procedures are as below:
•
First set speed at lowest position.
• Check which side the belt shifts to.
• If the belt shifts to right, tighten the right bolt and loosen the left bolt by using 6 mm Hexagonal
Wrench, until the belt is centred itself.
• If belt shifts to left, tighten the left bolt and loosen the right bolt by using 6 mm Hexagonal Wrench,
until the belt is centred. When adjusting the belt using the 6 mm Hexagonal Wrenches, it is important
to adjust the belt in half turn increments. Over adjusting the belt can cause damage to the mat.
MAINTENANCE