Trojan Technologies Aquafine TrojanUVLogic Series, Руководство по установке и эксплуатации, Страница: 80 / 186

Mechanical Wiping Systems (Optional)
Trojan UV Logic
TM
Operations & Maintenance
May 25, 2004
5-2
4. Remove the 1/4” #1 Flat screw from the
handle plate. Access to this screw may
require the removal of the handle from the
plate.
5. Unplug UV Sensor cable following
instructions for your model type. See below.
AM Models only:
Follow the 3’ cable to the UV Sensor to its
connection to the cable that connects the UV
Sensor and the CP. Unscrew the cables from
each other.
Short & Long lamp Models only:
Unscrew and unplug the UV Sensor from the
outside of the Conduit Support Bracket. As
shown in the following picture.
6. Loosen the Strain Relief on the End Cap. (If
there is no End Cap, skip the next step).
7. Remove the End Cap as per the Follow the
End Cap Removal and Installation
instructions in Chapter 4, UV Reactor (UVR).
8. Remove lamps as per the Lamp
Inspection/Replacement procedure found in
Chapter 4, UV Reactor (UVR ).
9. Remove the Wiper Assembly as per the
Sleeve Holder / Wiper Assembly Removal
procedure found in Chapter 4, UV Reactor
(UVR ).
Push Retainer Replacement
1. Complete the Manual Wiper Assembly
Removal procedure immediately preceding
this procedure.
2. If worn or damaged, remove and replace
Push Retainer with a new one. The Push
Retainer fastens the Stop Plate to the end of
Wiper Rod.
CAUTION
De-Pressurize & Drain the UVR.
Pressure must be relieved from
the system prior to any
maintenance, to prevent
damage to the equipment or
personal injury.
CAUTION
Remove the End Cap
completely. Do not allow the
End Cap to hang on the Wiper
Handle while conducting work.
¼” Flat Screw
on underside
Handle
Plate
UV Sensor Analog
Receptacle
Stop Plate
UVR
Chamber
Wiper Rod
Push
Retainer