Trojan Technologies Aquafine TrojanUVLogic Series, Руководство по установке и эксплуатации, Страница: 154 / 186

Alarms and Troubleshooting
Trojan UV Logic
TM
Operations & Maintenance
May 25, 2004
8-10
UV Sensor has failed
or is faulty. Remove and replace
failed or faulty UV
Sensor.
Missing UV Sensor
signal. Remove and replace
failed or faulty Cable
between UV Sensor
and CCB.
End of Lamp Life
Hours Alarm - Minor Lamps have reached
their EOL. (End of
Service Life) Replace all Lamps in
the system and set the
expired time to zero.
(See the Technician
Level Access Screens
of the System Settings
Screens in Chapter 7,
Control Panel (CP)). Order new Lamps
8.2 General Troubleshooting
Component Problem Remedy Frequency
Lamps Burned out Lamps
Change in colour of
Lamp glass Replace Component. On Lamp Status Alarm.
At End of Lamp Life
Lamps UV Lamps are off,
even if the ON switch
was activated.
•
Check if the
Remote control has
been activated
•
Check the system
for short circuits
and/or damaged
fuses, if necessary,
replace fuses.
As required.
Sleeves Fouling or coating of
the Quartz Sleeves,
Scratches. Replace Component. Clean monthly or when
low UV Alarm occurs.
UV Sensor Fouling or coating of
the Quartz window.
Moisture. Replace Component. Clean monthly or when
low UV Alarm occurs.
Sleeve Seal, O-Ring UV decay and brittle
pieces. Replace Component. Once a year or when
Sleeves are removed.
Sleeve Support
Washer UV decay and brittle
pieces. Replace Component. Once a year or when
Sleeves are removed.
Sleeve Bushing UV decay and brittle
pieces. Replace Component. Once a year or when
Sleeves are removed.