AWC708S Motion Control User Manual
WWW.SZTROCEN.COM
56
an impact on smoothness when turning.
During the cutting process, if the actual cutting speed is far less than the
working speed users have set, it indicates that the
【
Cut Jerk
】
is set too
small, so that the laser head cannot reach the set working speed quickly.
If the actual cutting speed is relatively fast, the cutting line will jitter, this
case indicates that the
【
Cut Jerk
】
is set too high and the parameter value
should be reduced. In the same way, if the
【
Space Jerk
】
is set too small,
the speed of laser head will not reach the set speed when there is no laser
output. If the parameter is set too large, the initial position of cutting
(after the laser head moving without laser) will jitter.
The start speed is the initial speed of the laser head from rest to start
movement. If the cutting line is too thick at the initial position of cutting,
it indicates that the parameter value is too small. If the line jitters at the
initial position of cutting, this parameter value is set too large.
The speed factor controls the speed of turning during cutting. If the cutting
line is too thick when turning, the parameter is too small. If the cutting
line is too thin when turning and the graphics cannot be cut completely,
this case indicates that this parameter value is set too large, users should
set a smaller value.
The
【
Engrave ACC
】
is the change rate of speed during engraving. This
parameter is only valid during engraving. During the engraving process, if
the space distance of laser head is too large, then the
【
Engrave ACC
】
is
