6
T40i
FITTING TO THE WALL
• Unscrew the top and bottom retaining screws
(fig.6)
and lift the cover from the backplate.
NOTE:
The control knob is an integral part of
the cover. DO NOT attempt to remove it.
• Decide on the cable entry position, either top
or rear.
• If top entry position is chosen, the cut-out in
the backplate must be removed
(fig.7)
.
• Loosely connect the supplied flexible hose to
the T40i inlet connection and the mixer valve
outlet. Using the backplate as a template,
hold it against the wall, making sure there is
some slack in the hose and mark the position
of the fixing holes
(fig.8)
. Remove the
flexible hose from the T40i and mixer valve.
Fig.8
Fig.7
Fig.6
WARNING
Check there are no hidden cables or
pipes before drilling holes for wall plugs.
Use great care when using power tools
near water. The use of a residual current
device (RCD) is recommended when
using power tools.
• Drill and plug the wall. An appropriate drill bit
should be used. If the wall is brick,
plasterboard or a soft building block,
appropriate wall plugs and screws should be
fitted.
• Screw the top fixing screw into position
leaving the base of the screw head protruding
6mm out from the wall.
• Hook the backplate over the top screw and fit
the bottom fixing screw into position.
• The bottom fixing hole is elongated to allow
for out of square adjustment. Tighten both
screws when correctly positioned.
