10
T40i
OPERATING
• Turn on the electric isolating switch.
• Turn on the water supply at the mixer valve/
tap and adjust to a showering temperature.
• Switch the T40i control knob to ‘start’
(fig.14)
. The pump will start and the neon
will illuminate.
• Adjust shower temperature as normal.
NOTE:
With the push-on hose systems the T40i
pump should not be switched on until water
flows from the sprayhead.
• When showering is completed, switch the T40i
control knob to ‘stop’
(fig.15
).
• Turn off the mixer valve or taps.
• Turn off the electric isolating switch.
Fig.14
Fig.15
ADVISORY - CLEANING
It is recommended that all products
are cleaned using warm, soapy water.
DO NOT
use abrasive or aggressive
chemical cleaning products as this may
affect the product surface finish and
invalidate your guarantee.
MAINTENANCE
Before cleaning, turn off the unit at the isolation
switch to avoid accidental switching on of the
booster pump.
IT IS IMPORTANT TO KEEP THE EXISTING
SPRAYHEAD CLEAN IN ORDER TO MAINTAIN
THE PERFORMANCE OF THE SHOWER.
The hardness of water will determine the
frequency of cleaning. For example, if the shower
is used every day in a very hard water area, it
may be necessary to clean the sprayhead on a
weekly basis.
If the T40i pump is not used for lengthy periods,
it is recommended to turn on the water at the
mixer valve/tap then switch the pump on for two
or three minutes periodically to prevent the
motor shaft seals from seizing.
DO NOT RUN THE T40I PUMP DRY.
