1
T40i
IMPORTANT - GENERAL GUIDANCE NOTES
1
GENERAL
1.1
Products manufactured by Triton are safe
and without risk provided they are
installed, used and maintained in good
working order in accordance with our
instructions and recommendations.
1.2
DO NOT
operate the unit if it is frozen or
suspected of being frozen. It must thaw
out before using.
1.3
Switch off the electrical supply at the
mains before removing the cover.
1.4
Read all of these instructions and retain
them for later use.
1.5
DO NOT
connect to the mains water
supply.
1.6
Isolate electrical and water supplies
BEFORE
proceeding with the installation.
1.7
DO NOT
connect to modulating type
combination boilers, multi-point hot water
heaters and unvented or thermal storage
systems.
1.8
Contact Customer Service (see back
page), if any of the following occur:
a) If water ceases to flow during use.
b) If the unit shows a distinct change in
performance.
c) If the pump is frozen.
d) If water has entered inside the unit
because of incorrectly fitted cover.
1.9
DO NOT
restrict flow out of the pump by
placing the sprayhead in direct contact
with your body.
1.10
This product is not suitable for
mounting into steam rooms or
steam cubicles.
1.11
DO NOT
use excessive force when making
connections to the flexible hose or
sprayhead, finger tightness is sufficient.
1.12
All hose connections
MUST
be completed
BEFORE
making the electrical
connections.
2
ELECTRICAL
2.1
The installation must comply with BS 7671
‘Requirements for electrical installations’
(IEE wiring regulations) or any particular
regulations as specified by the local
Electrical Supply Company.
2.2
This appliance MUST be earthed.
2.3
In accordance with ‘The Plugs and Sockets
etc. (Safety) Regulations 1994’, this
appliance is intended to be permanently
connected to the fixed wiring of the
electrical mains system.
2.4
Make sure all electrical connections are
tight to prevent overheating.
2.5
Fuses do not give personal protection
against electric shock.
2.6
A 30mA residual current device (RCD)
MUST
be installed in all UK electric and
pumped shower circuits. This may be part
of the consumer unit or a separate unit.
2.7
Switch off immediately at isolating switch
if water ceases to flow during use.
2.8
Switch off at isolating switch when
not in use. This is a safety procedure
recommended with all electrical
appliances.
2.9
Other electrical equipment i.e. extractor
fans, pumps,
MUST NOT
be connected to
the circuits within the unit.
3.0
As with all electrical appliances it is
recommended to have the unit and
installation checked at least every two
years by a competent electrician to ensure
there is no deterioration due to age and
usage.
