2
T40i
INTRODUCTION
This book contains all the necessary fitting and
operating instructions for your T40i booster
pump. Please read them carefully.
The installation must be carried out by a suitably
qualified person and in the sequence of this
instruction book.
Care taken during the installation will ensure a
long, trouble-free life from your booster pump.
The T40i booster pump is designed to improve
the flow rate through an existing bath/tap mixer
valve. It is
NOT
designed to pressurise the water
supply but only to assist the flow.
IT MUST ONLY
be fitted to new or existing
gravity fed shower mixer systems.
The unit is easy to install requiring no plumbing,
only simple screw-on hose connections and a
suitable power supply.
NOTE:
It must NOT be used with
instantaneous water heaters.
This product is suitable for installation in a
bathroom.
DO NOT
install the unit so close to the bath that
the supplied hose becomes twisted or kinked and
restricts the water flow.
SPECIFICATIONS
Electrical
Voltage: ............................... 240V
Pump motor rating: ............. 73 Watt (nominal)
Water
Inlet connection – ½” BSP male thread.
Outlet connection – ½” BSP male thread.
Entry Points
Water – bottom left.
Cable – top right, rear right.
Materials
Backplate, cover, controls – ABS.
Dimensions (in millimetres)
Height ....... 230
Width ........ 217
Depth ........ 80
Standards and Approvals
Splashproof rating - IPX4
Complies with the requirements of current British
and European safety standards for household and
similar electrical appliances.
Complies with requirements of the British
Electrotechnical Approvals Board (BEAB).
Meets with Compliance with European
Community Directives (CE).
This product is rated at:
15 minutes on / 45 minutes off.
