15
Rosato
High/
Economy
Cold
Temperature
control
Maximum Cold
Maximum Hot
Start/Stop
button
USER OPERATING INSTRUCTIONS
10
check list
SECTION
OPERATING THE SHOWER
-
(
fi
g.18)
• When the electricity supply to the shower
is switched on at the isolating switch, the
“power”
indicator will light.
To start the shower
• Press the
START/STOP
button and water will
begin to flow.
NOTE:
Default start up setting is the
HIGH
setting.
To stop the shower
• Press the
START/STOP
button and the
phased shutdown will begin. Water will cease
to flow after a few seconds.
To use the control buttons
• There are two control buttons –
HIGH/ECONOMY
and
COLD
(fig.18)
.
• The upper button –
red symbol
is for
switching between the
HIGH
and
ECONOMY
power setting.
• The
HIGH
setting allows the highest flow
achievable for your preferred temperature.
This setting should normally be regarded as
optimum shower performance throughout the
year.
• The
ECONOMY
setting uses less energy
when the ambient mains water temperature
is high during hot months.
• The
HIGH/ECONOMY
button alternates
between the two settings: press the button
once
to select the
ECONOMY
setting,
press
the button again
to reselect
HIGH
.
• Temperature adjustment at this setting is via
the temperature control.
• The lower button –
blue symbol
is for
COLD
water only. Adjusting the temperature control
at this setting will only increase or decrease
the flow of the water from the showerhead.
(It will not alter the water temperature.)
IMPORTANT:
it will take a few seconds for the tem-
perature to stabilise once changes have been made.
NOTE:
If the stated flow rate required for the unit
cannot be met due to low water pressure, it will
be necessary to operate the unit on the
Economy
setting during the warmer months because of
flow rate limitations entering the unit.
Fig.18
