Triton NOVA Thermostatic Series, Инструкция по установке и эксплуатации

Страница: 19 / 28

19
Electric shower
OPERATING THE SHOWER
Make sure the commissioning procedure
has been carried out.
Start/Stop
To start the shower press the start/stop button
and water will flow.
NOTE: It is advisable to check showering
temperature is satisfactory by testing with
your hand before stepping under the shower
head. There will always be a time delay of a
few seconds between selecting a flow rate
and the water reaching the stable
temperature for that flow rate.
To stop the shower press the start/stop button
and water will cease to flow.
Power Selector
The power selector has three positions - COLD,
ECONOMY and HIGH .
The cold setting - single blue line - does not
provide any heat from the heater can to the
incoming water.
Economy - single red line - uses only one of the
elements within the heater can.
NOTE: If the stated flow rate required for the
unit cannot be met due to low water pressure,
it will be necessary to operate the unit on this
setting during the warmer months because of
flow rate limitations entering the unit.
The high setting - double red lines - uses both of
the elements within the heater can.
IMPORTANT:
It will take a few seconds for the
temperature to stabilise once changes have
been made.
Power selector
Cold Cold
Economy Economy
High High
Temperature
control
COLDER COLDER
Fig.22
HOTTER HOTTER
Start/Stop button Start/Stop button
WARNING
If restarting immediately after stopping,
be aware that a slug of hot water will be
expelled for the first few seconds.