Body dryer
2
INTRODUCTION
This book contains all the necessary fitting and
operating instructions for your Triton Luxury
Body Dryer. Please read them carefully.
The Body Dryer installation must be carried
out by a suitably qualified person and in the
sequence of this instruction book.
Care taken during the installation will provide a
long, trouble-free life from your body dryer.
The Body Dryer has been designed for use in a
bathroom or shower room for the purpose of
personal body drying. The dryer should not be
used for any other purpose.
Never install in a shower cubicle or steam
room.
SPECIFICATIONS
Electrical
Nominal power
Nominal power
rating at 240V
rating at 230V
9.0kW – (40A MCB rating) 8.3kW – (40A MCB rating)
Trickle current on OFF mode is 0.04A at 240V
(9.6W) but is not isolated.
Minimum cross sectional area of supply cable is
6mm². Derating factors should always be taken
into consideration when selecting cable size.
Materials
Main unit – 20% Glass filled Polypropylene
Cover – ABS
Dimensions
Width – 335mm, Length – 625mm,
Height – 175mm
Above ceiling – 140mm
Below ceiling – 70mm (cover)
Weight – 7kg
Packed weight – 10kg
Standards and Approvals
Complies with requirements of current British
and European safety standards for household
and similar electrical appliances.
Complies with requirements of the British
Electrotechnical Approvals Board BEAB.
Meets with compliance with European
Community Directives CE. EMC
ADVICE TO USERS
The following points will help you understand
how the Body Dryer operates:
a.
The unit consists of a high powered two
speed fan and 2 x 4.5kW heater elements
which are fully controllable using the hand-held
controller (supplied). Air is drawn in through
the filter, passed across the elements and then
discharged downwards.
b.
DO NOT place pressurised aerosol cans in or
under the hot air flow. Always electrically isolate
the dryer or dryer/shower combination when
not in use.
c.
Temperature sensors are fitted to the unit for
your safety. However, the best sensor is you. If
you find the airflow or room temperature rises
to uncomfortable levels switch off or regulate
the flow through use of the controller. Never
leave alone those unable to recognise or react to
discomfort with the dryer switched on.
For ideal comfort and drying time the ceiling
height should be between 2.2m to 2.5m.
The dryer has a 10-minute preset cut off.
d.
The unit can be connected in combination
with an electrical shower rated from 8kW
up to 10.5kW. The electrical safety features
incorporated in the unit do not allow the Body
Dryer to be operated while the shower is on and
vice versa.
e.
The hand-held controller should be kept
away from sources of water.
f.
The LED’s incorporated into the cover show
the operational status of the Body Dryer or
any fault condition. If you suspect the unit to
be faulty unqualified attempts to rectify the
situation should be limited to isolating and
switching on the unit via the pull cord and
operation of the hand-held controller
(see
commissioning instructions)
. All other problems
MUST be attended to by a competent electrician
or service engineer.
Due to continuous improvement and updating,
specification may be altered without prior notice.
Replacement parts can be ordered from Customer
Service. See
‘spare parts’
for details and part numbers.
