Body dryer
13
COMMISSIONING
IMPORTANT:
Before commissioning make
sure both the electrical connection cover and
ceiling are in place.
The unit has two fan speeds and two heat
settings in any combination.
A single audible signal confirms a change
in speed has been effected. A double bleep
confirms the unit is in full heat mode. The unit
can also be used in fan only mode.
Establish the electrical supply to the pull cord
switch assembly by replacing any fuses and
activating the RCD device.
Operate the pull switch to connect mains power
to the unit. Momentarily, all three LED’s will
flash on but only the green LED will remain on.
Test Sequence
Carry out the functions shown in
Table C
.
When first operated you may experience an
odour from the unit, this will be due to the
heating elements being operated for the first
few times. This odour should quickly disappear.
Overheating is a sign that something is wrong.
If the reason for overheating is not obvious
then switch off the unit at the mains supply and
contact Triton Customer Service for advice.
DO NOT attempt any repairs as there are
no user serviceable parts in the unit.
The body dryer has a 10-minute maximum run
time after which the unit will switch itself off.
To restart the dryer reselect a setting; this
prevents permanent operation of the dryer
when a button is accidentally pressed.
Any associated electric shower should now be
checked for functionality as shown in
Table D
.
FUNCTION
Press the Fan
only button on
the hand-held
controller.
Press the Fan
Fast button.
Press the Low
Heat button.
Press the High
Heat button.
Press the Fan
Slow button.
Press the High
Heat button.
Press the Fan
only button.
Press STOP
button.
EFFECT
Fan will start up in slow
mode.
Air output from the unit will
be at ambient temperature.
Fan speed increases to the
maximum.
First heat element is
connected and warm air is
felt.
Second heat element
is connected and air
temperature increases.
Fan speed decreases to lowest
setting.
Air temperature increases
further.
Second heat element is
disconnected.
Air temperature decreases.
Fan runs at its slowest speed.
Ambient temperature air will
be felt from unit.
Fan stops.
Table C
If this works as it
should, with the
shower running,
try to turn on the
body dryer.
Switch the shower
OFF.
END OF
COMMISSIONING
Circuitry in the unit
should prevent the body
dryer switching on and
the shower switching off.
Full functionality is
returned to the body
dryer controller.
Table D
