Body dryer
10
ELECTRICAL CONNECTIONS
SWITCH OFF THE ELECTRICITY SUPPLY AT
THE MAINS.
Fig.15
shows a schematic wiring diagram.
Fig.16
shows a connection diagram which
must be followed without deviation. This is
particularly important where a body dryer and
shower combination are using the same feed
cable.
A built-in safety feature of the body dryer
prevents both devices from operating at the
same time and overloading the electrical wiring.
Note:
The terminal block that connects the
shower cable to the dryer is LIVE whenever the
dryer is not electrically isolated.
Live conductor (Brown or Red)
to terminal marked
L
Neutral conductor (Blue or Black)
to terminal marked
N
Earth conductor to terminal marked
(yellow and green)
E
The mains cable should be firmly secured using
the clamps provided.
The earth wire should be physically longer than
the live and neutral wires.
IMPORTANT:
Where a shower is involved
earth continuity is essential to provide a safe
operating environment.
Fully tighten the terminal block screws and
make sure no cable insulation is trapped under
the screws. Loose connections can result in the
cable overheating.
Notes
Good wiring practice advises that:
The supply cable earth conductor must be
sleeved.
The outer sheath of the supply cable must be
stripped back to the minimum.
The supply cable must be secured either by
routing through conduit or in trunking or by
embedding in the wall, in accordance with
current IEE regulations.
240V Shower feed out
240V Mains feed in
Fig.16
Fig.17
L
N
N
L
E
1
2
3
4
5
6
7
8
5
6
Fig.15
1.
Terminal block
2.
Earth post
3.
Body dryer PCB
4.
Fan
5.
Heating element
6.
Thermal contact
7.
Cover PCB
8.
Infrared receiver
