![Tripp Lite UBC41 Скачать руководство пользователя страница 4](http://html1.mh-extra.com/html/tripp-lite/ubc41/ubc41_owners-manual_1164509004.webp)
4
Operation
Mounting (Optional)
LED Indicators
LED (Color)
LED Status
Operation Status
Description/Solution
Normal Operation
Bulk/Accept (Yellow)
Solid
Soft start
Current is charging slowly
Slow flash
Bulk constant current charging
Battery drawing maximum charge current
Fast flash
Absorption constant voltage charging
Battery reaches set voltage limit; adjusts to draw
less charge current
Very fast flash
Finish constant voltage charging
Battery near 100% capacity; approaching
floating status
Charging/Float (Green) LED
Slow flash
Floating
Battery charge full
Fast flash
Floating
Battery charge full and floating current < 0.5 A
Abnormal Operation
Error (Red)
Flash 2x
Charger cannot connect to battery or broken
DC fuse
Check fuse and replace if broken
Flash 3x
Battery voltage is too high or too low
Check that battery voltage selected on charger
matches battery’s voltage
Flash 4x
Shorted internal thermal sensor or open circuit
Defective thermal sensor; follow the
Service
instructions on the next page
Flash 5x
Internal overheat protection
Unit cooling down; will automatically restart upon
reaching average internal operating temperature
Notes:
• Battery voltage selection cannot be changed during charging; the battery must be disconnected before selecting the charger voltage.
• The battery is fully charged when the green LED is illuminated. You can stop charging the battery at this point or keep it connected in floating status.
• To end a charging session, disconnect the AC power cord from the source, then disconnect the charger’s clamps from the battery terminals.
The 4-in-1 Charger can be mounted to a horizontal surface. To
mount, install four fasteners (not included) through the charger’s
mounting slots into a rigid surface. Secure the fasteners as far
back in the mounting slots as possible, otherwise the fasteners
may loosen and cause the charger to slide back and forth.
Note:
The user is responsible for determining if the hardware and mounting
surface are suitable to support the charger.
115
Содержание UBC41
Страница 20: ...20 Tripp Lite 50 50 C...
Страница 22: ...22 Bulk Accept 100 Charging Float 0 5 2 3 4 5 4 1 115...