1
2
3
4
3
Assembling the Chimney Base
1
Position the 4 side panels of the Chimney Base in accordance
with Diagram
1
and secure the attachments with 8 of the M4
nuts that screw onto the pre-installed threaded posts.
Once assembled, this piece can be put aside for later use.
Installation
Assembling the Adjustable Chimney Slider
2
Position the 4 side panels of the Adjustable Chimney Slider
in accordance with Diagram
2
and secure the attachments
with the remaining 8 M4 nuts that screw onto the pre-installed
threaded posts.
Once both the Chimney Base and Slider have been assembled
you can move on to stacking.
Stacking the Chimney
3
With both the Chimney Base and Adjustable Chimney Slider
assembled, position and fit the slider on top of the base.
4
The holes in the sides of the Chimney Base and locking pins
in the sides of the Chimney Slider allow the chimney to be
adjustable in height with a range of 20” (flat, no height) to
34” (adjusted, full height). For installation purposes, it is
recommended to initially stack the two pieces in the 20” (flat,
no height) position until installed on the rack enclosure. To do
so, pull out the four locking pins and slide the Chimney Slider
all the way down over the Chimney Base into the 20” position
as seen in Diagrams
3
and
4
.
201204262-93-2958-EN.indd 3
6/4/2012 2:39:49 PM
