6
7
8
5
4
Installation
continued
Installing the Cable Access Cover
6
Place the entire panel onto the top of your rack enclosure as
shown in Diagram
6
.
Note: The SRTHERMDUCT will fit most
standard rack installations, however, it is up to the user to
determine the fitness and configuration of their rack enclosure
before installation.
Installing the Chimney
Once the Cable Access Cover has been placed on top of the rack
enclosure you can install the chimney.
Warning! Heavy! Do not attempt to install alone!
Use at least two people for the installation!
7
To install the chimney, attach 2 of the feet to the Cable Access
Cover and the other 2 feet to the frame of the rack enclosure
using the 4 M8 screws as seen in diagram
7
.
8
Once the chimney has been secured to the rack, you can
adjust the height of the chimney. To do so, pull up on the
Adjustable Chimney Slider until you have reached the desired
height. Lock the Slider in place by pushing in the 4 locking
pins. (See Diagram
8
.)
Installing the Enclosure Bottom Panel
5
Install the bottom panel to the enclosure using the 4 provided
M4 screws. Slide the panel underneath your enclosure and
have another person hold it up in place while you start the
screws from the inside of the enclosure. The M4 screws will
not require nuts as the bottom panel provides 4 threaded
holes.
You can also install this panel from the inside of the
enclosure. To do so, you must remove all the vertical rails,
then simply lay the bottom panel down onto the bottom of
the enclosure frame. Screws do not need to be used in this
configuration.
201204262-93-2958-EN.indd 4
6/4/2012 2:39:51 PM
