3
Installation
Surge Protector Care and Maintenance
1
Connect Your Surge Protector to Your AC Power Line
Plug the power cord into a utility outlet. The surge protector’s power cord should only
be connected to a standard 3-wire grounded 120V AC 60 Hz outlet.
2
Connect AC Equipment to Your Surge Protector
Plug the AC power cords of your equipment into your surge protector. Do not use
extension cords or adapters that eliminate the connection to ground. DO NOT
OVERLOAD your surge protector. Each outlet can handle a load of up to 12A, but do
not exceed a total load of more than 12A for all outlets. If the circuit breaker trips,
outlets will cease to provide power. Reduce the load on the surge protector down
to your unit’s amp rating by unplugging excess equipment, then depress the circuit
breaker button to reset and restore power.
Warning:
Do not spray with liquid cleaning products.
• To clean, unplug unit and wipe with a clean cloth. Cloth may be dampened with all-
purpose cleaner.
• Check status and operation of LED, if applicable.
• Check Circuit Breaker (CB) status. Normal operation requires CB be depressed.
• Ensure mechanical integrity of case.
• Ensure mechanical integrity of power cord. It should be free of cuts, frays, and
exposed wires/conductors.
• Ensure mechanical integrity of built-in outlet safety covers, if applicable.
• Tripp Lite recommends annual inspection of its products when they are used in a
typical hospital/medical/healthcare/assisted living environment.
17-04-339-933056.indb 3
5/5/2017 8:47:41 AM