4
Installation
5.
Connect the CH1 RJ45 port on the transmitter to the CH1 RJ45 port on
the receiver using Cat5e/6 cable.
Note:
See the installation diagram for maximum extension distance at 1080p
(60Hz) video resolutions.
6.
Connect the CH2 RJ45 port on the transmitter to the CH2 RJ45 port on
the receiver using Cat5e/6 cable.
Note:
See the installation diagram for maximum extension distance at 1080p
(60Hz) video resolutions.
7.
Connect the HDMI input on the receiver to the HDMI monitor.
8.
Connect the IR-RX cable to the IR port on the receiver unit.
Note:
The IR-RX cable receives the IR signal from a remote control. Locate the
IR-RX unit in an area with a clear line of sight to the remote control.
9.
Turn on the connected equipment. The orange LED on the transmitter
unit will illuminate to indicate it is receiving a signal from the source.
10.
If necessary, use the equalization control to adjust the video image.
Note:
An improper Equalization setting can result in no image being displayed at
all. If no image is displayed on your monitor, try adjusting the Equalization.
16-04-148-9334B1-EN.indd 4
5/2/2016 3:03:01 PM
