4
Hardware Setup
continued
Rack Mounting Safety Instructions
• Before working on the rack, make sure that the stabilizers are secured to the rack, extended to the floor, and that the full weight of the
rack rests on the floor. Install front and side stabilizers on a single rack or front stabilizers for joined multiple racks
before
working on the
rack.
• Always load the rack from the bottom up, and load the heaviest item in the rack first.
• Make sure that the rack is level and stable before extending a device from the rack.
• Use caution when pressing the device rail release latches and sliding a device into or out of a rack; the slide rails can pinch your fingers.
• After a device is inserted into the rack, carefully extend the rail into a locking position, and then slide the device into the rack.
• Do not overload the AC supply branch circuit that provides power to the rack. The total rack load should not exceed 80 percent of the
branch circuit rating.
• Make sure that all equipment used on the rack, including power strips and other electrical connectors, is properly grounded.
• Ensure that proper airflow is provided for devices in the rack.
• Ensure that the operating ambient temperature of the rack environment does not exceed the maximum ambient temperature specified
for the equipment by the manufacturer.
• Do not step on or stand on any device when servicing other devices in a rack.
The B051-000-AC can be placed on any level surface that can safely support its weight plus the weight of attached cables. When placing
the unit on a desktop, remove the backing material from the rubber feet that came with this package and affix them to the bottom panel
at the corners.
Note:
To ensure adequate ventilation, allow at least 5 cm on each side, and 13 cm at the back for power cord and cable clearance.
Stacking
12-176 93-3159_RevC.indd 4
8/27/2012 2:48:15 PM
