11
Operation
continued
Hot-Swapping
The B021-02R-17 supports hot-swapping, allowing components to be connected and disconnected without
having to shut down the console.
Hotkey Commands
The hotkey commands in the table below are available for controlling the console. Each key in the hotkey
command must be pressed one at a time.
Hotkey
Description
[Ctrl], [Alt], [Shift], [p], [c],
[Enter]
This is the default computer setting for the console. It should be selected
when connecting anything other than a Sun computer.
[Ctrl], [Alt], [Shift], [s], [u], [n],
[Enter]
When a Sun computer is connected, use this setting for optimal
compatibility.
[Ctrl], [Alt], [Shift], [u], [p], [g],
[r], [a], [d], [e], [Enter]
Activates firmware upgrade mode. (See Firmware Upgrade on page 12
for details)
[Ctrl], [Alt], [Shift], [l], [Enter]
Enables access to the connected computer/KVM via the built-in (local)
console only. Access via the external (remote) console is disabled.
[Ctrl], [Alt], [Shift], [r], [Enter]
Enables access to the connected computer/KVM via the external (remote)
console only. Access via the built-in (local) console is disabled.
[Ctrl], [Alt], [Shift], [l], [r], [Enter]
or [Ctrl], [Alt], [Shift], [r], [l],
[Enter]
Enables access to the connected computer/KVM via either the built-in
(local) or external (remote) console. This is the default setting.
Note:
1.
Console hotkey settings are not stored indefinitely. If the console is powered off, it will revert to the default
settings when powered back on.
2.
If the console is connected to a KVM switch that uses the hotkey combination [Ctrl], [Alt], [Shift], you will not
be able to access that KVMs hotkey commands. The console will recognize the [Ctrl], [Alt], [Shift]
combination as its own hotkey sequence.
