Comfort
BREEZE
TM
Model CB707
I n s t a l l a t i o n , O p e r a t i o n , & M a i n t e n a n c e M a n u a l
6
www.trioniaq.com
level to ensure that the unit will be installed level and plumb.
If the unit is not level and plumb, ideal operation may not
be obtained.
3. Drill the mounting holes as shown on the template for
mounting the bracket to the wall.
4.
Attached the mounting bracket to the wall using the lag
screws provided.
5.
Place the base of the unit on the mounting bracket and se-
cure using the screws provided. See Figure #1 for details.
6.
Once the humidifier is mounted, place the dome on top of
the unit. It will snap into place. Ensure that the direction of
discharge is facing away from the wall.
7.
Refer to the plumbing and electrical connection sections to
complete the installation.
4.2.2 Duct Mounting The Humidifier
Figure 2
IMPORTANT
The unit must be installed so that interconnection can be
made to the source of electrical supply without the use of an
extension cord.
1.
Referring to figure 2, using the mounting template, mark the
mounting holes on the duct. Ensure that the discharge tube
is lined up with the centerline of the duct.
2. While holding the template against the duct, check with a
level to ensure that the unit will be installed level and plumb.
If the unit is not level and plumb, ideal operation may not
be obtained.
3.
If you are installing the humidifier on a return duct, also
mark the discharge hole as indicated on the template.
4. Drill the mounting holes as shown on the template for
mounting the bracket to the duct.
5.
Cut out the discharge hole while taking care not to injure
yourself. Once the hole is cut out, ensure that the edges
will not damage the humidifier.
6.
Attached the mounting bracket and discharge flange to the
wall or duct using the screws provided. Ensure that the
gasket is placed between the duct and the flange.
7.
Place the base of the unit on the mounting bracket and se-
cure using the screws provided. See Figure #2 for details.
8.
Insert Nozzle Extension Tube through gasket hole in duct
approximately 2”.
9.
With the humidifier mounted, place the dome on top of the
unit. It will snap into place. Ensure that the direction of
discharge is correct for your application; either wall or duct
mount.
10.
Insert Nozzle Extension Tube from duct into humidifier
dome, discharge nozzle. Tube will insert approximately 1”
inside dome discharge nozzle against stops.
4.2.3 Ceiling Mounting The Humidifier
Figure 3
1.
Refer to Figure 3. The humidifier base has holes at the four
corners that may be used to suspend the unit from the ceil-
ing using threaded rods.
2.
Using #10-32 threaded rods, suspend the unit at least 24
inches from the ceiling to prevent mist from impinging on
the ceiling.
3. Ensure that the discharge mist is not entrained within air
currents that may cause the mist to accumulate on the
threaded rods or back onto the unit itself. Dripping may
occur.
4.
Once the humidifier is mounted, place the dome on top of
the unit. It will snap into place. Ensure that the direction of
discharge is correct for your application.
5.
Refer to the plumbing and electrical sections for completing
the installation.
