3
1
1
2
2
2
2
3
3
3
3
70 mm
2
1
Trimline Opal
Installation instruction
4
NOTE
Do not start the installation until you have read and
understood the installation instructions.
•
Do not place the appliance on its side.
•
Place the appliance on a stable surface. Remove the glass
panel (see Paragraph 2.4
Removing the glass panel
) so you
can take out the packaged parts. Check it for damage and
defects.
2.2 Cover removal
1
Lift the lid and support it if necessary, for example with a
small length of wood
1
. Remove the upper and lower covers
from the mantle. These are both attached with 4 hooks per
cover. Slide the cover upwards first
2
and then pull it down
3
. Both the upper and lower covers can be removed. Put the
gas fire in its place, keeping a distance of at least 50mm away
from the wall at the rear. Use the adjustable feet to ensure the
appliance is level. Adjust the height between the mantle and
the floor to 70mm.
2.3 Connection to the gas supply pipes
•
You can determine where the gas supply pipes will be
placed, dependent on the layout. Ensure control equipment
is not twisted during installation and there is no excessive
tension. Accessibility of various connection points in relation
to components needs to be maintained. After installation,
check the connections are gas-tight. Use a 3/8″ gas tap with
a connector. Also ensure the gas supply pipe is free from dirt
or sand. To prevent damage to the gas control equipment,
the gas connection must be isolated from the electrical power.
•
At the rear, one of the two breakout plates can be removed,
if necessary, to feed in the gas supply pipe.
2
The concentric
pathway can then be put in place, see Chapter
7 Concentric
pathways
and
8 Concentric flue system
.
•
Ignite the appliance for the first time without a glass panel.
Check all the gas connections for leaks again. You can then
switch the appliance off and put the ceramic wood set in
place (see Chapter
3 Installation of the ceramic wood set
and dispersion medium).
