Standard Operating Procedures — Section 1
Push to Start
Pressing the engine start button will begin the process of detecting a
FOB in range (CJ11P2 active). The TriMark system will look in the area
of the driver. If the FOB is in range, the FOB will respond with single
blink. If the FOB is authorized, the TriMark system will tell the motor
controller that it may start the engine.
Running
Once the engine is running, the FOB is not required to keep the vehicle
running.
Note:
You can drive away without your FOB in the vehicle. You will not
be able to start the vehicle again without the FOB present.
Shutdown
With your vehicle in park, a short press of the start/stop button will turn
off the vehicle.
Locking (typical)
Press and hold the Button 1/2 button on the keypad or press the lock
function on the FOB.
Unlocking Entrance (typical)
Type in the five digit code followed by the 1/2 button or press the unlock
function on the FOB.
Note:
Programming new codes into your keypad can be found in
section
Keypad Operation and Features - Section 3
under Teaching
Keypad New Authority / Access Codes.
Alarm Functionality
Arming the Alarm:
By locking the door with the touchpad, “lock/latch all” input (CJ1P10) or
the key FOB will attempt to set the alarm.
The word “attempt” is used above because several conditions can block
the alarm from being armed:
Parking brake not set (in gear)
Any security inputs are in the active state
Any door ajar input are in the active state
6
Содержание 500-1300 e-ASK
