Keypad is not functioning
No audible beep when
button is pressed
Check for power
It beeps one long and two
shorter beeps
This is a CAN error and is usually due to
wiring harness issues. Please refer to
Appendix F: CAN requirements for harness
requirements.
The keypad can’t communicate with
other controllers so it is nonfunctional
until the CAN issue is resolved. This
includes programming.
Make sure module has power
There are two LEDs one red and one
green. They are located inside the
module. One or the other should be
blinking or on. Connector Locations
section identified the location
Replace keypad
I put the 5 digit code in and
it doesn’t do a double beep Reprogram access code
Pressing the Start button won’t start the vehicle
The button blinks three
times and nothing happens
Make sure FOB is near the steering column
Cycle power to system (please read the
“Note” above)
Replace battery
The LED can blink and still not have the
power to send messages
Check fuses
Check the CJ13P14 wire. This is an
antenna and should be laid out as
described in Appendix A: Mounting e-
ASK
Components.
Check Air pressure levels
Break pressure starts the FOB search
protocol. Without the search initiated
correctly, this error will occur
Appendix E: Troubleshooting
Note:
A
complete power cycle
requires that power is removed for 2
minutes!!!
28
Содержание 500-1300 e-ASK
