TriMark 500-1300 e-ASK, Руководство пользователя

Страница: 12 / 36

will illuminate green and the compartment will unlatch. If the Bay/
Cargo access is not enabled, the push buttons will illuminate red and
deny access.
Teaching Keypad New Authority / Access Codes
All codes are exactly 5 digits. You may reuse numbers. Changing the
authority code erases all access codes. It is highly recommended that
you change your authority code from the default code.
Programming Authority Code:
Note: There is a video of how to do this on https://
www.trimarkcorp.com/en/easkum.aspx, under videos, please select
"Programming new keycodes on all other keypads"
In this video:
1/2 button is the 1 button
2/3 button is the 2 button
4/5 button is the 3 button
6/7 button is the 4 button
9/0 button is the doorbell button
Preparation:
The keypad is plugged into the coaches wiring
harness with a four pin connector. You will need
to unscrew the keypad and pull it away from the
coach to expose this connector. The yellow wire that is tucked into the
sheathing is the wire that initiates programming mode.
Programming:
1. With the keypad still plugged in, short the yellow wire to the
black wire (GND) momentarily. This will cause the keypad to
beep for one second.
2. Enter the desired 5-digit code twice (after programming the
system will immediately exit learn mode).
3. Test the code by unlocking the entrance door
Note: We recommend changing the access code when RV is acquired.
The system automatically stores an access code the same as your
authority code in location Button 1.
Programming Access Codes:
Preparation:
All codes are exactly 5 digits. You may reuse numbers. Have a number
chosen.
Programming:
1. Press and hold Button 3 for 5 seconds. The keypad will beep
and begin flashing when it is held long enough
2. Enter the 5 digit authority code
12