Tridonic luxCONTROL DaLI Msensor 5DPI 14, Руководство по эксплуатации продукта

Страница: 19 / 52

Product manual DALI MSensor 5DPI 14 | 06-2017 | 1.1 | en
Constant light control
c
15 / 48
Procedure with IR SMART Controller
/ REMOTECONTROL IR6
For the names of the buttons with letters, see the figure showing the IR SMART Controller.
Procedure with DALI-RC
For the names of the buttons with letters, see the figure showing the DALI RC.
Procedure with masterCONFIGURATOR
Setting the ambient light-based bright-out and bright-in
This function can be activated or deactivated. The individual parameters can be adjusted. All settings can be made
by using the masterCONFIGURATOR software (V2.12 or later) (see Reference list).
I
NOTICE
The factory settings of the ambient light sensor are appropriate for normal conditions in a typical office room.
Factors such as the room height, type of furniture and nature of the floor can make it necessary to make
adjustments.
Check that ambient light control adjusts the lighting to desired levels. _
In case of incorrect operation or unsatisfactory results: adjust the brightness setpoint. _
I
NOTICE
A suitable brightness setpoint is typically defined by using a lux meter to make a localised brightness
measurement. The results obtained may vary depending where the measurement is made and what the external
lighting conditions are.
Check ambient light control at various locations within the measuring area and under varying external
lighting conditions. _
Make sure that the selected brightness setpoint takes into account varying conditions. _
Set the desired brightness by pressing the Up/Down button (F and G) _
Save the new brightness setpoint by pressing the SET button >3seconds. (C)
→ DALI MSensor briefly dims the luminaire group up and down _
Set the desired brightness by pressing the +/- button (J) _
Save the new brightness setpoint by pressing the AUTOMATIC button (K) for >3seconds.
→ DALI MSensor briefly dims the luminaire group up and down _
Directly enter the brightness setpoint _