Trident TVGA 9000I, Руководство пользователя

Страница: 14 / 64

If
you
have an IBM PC or PC/XT: IBM PC and PC/XT motherboards use
a
DIP switch to identify the type
of video display adapter installed in the
system.
If
you
are installing the adapter in an IBM PC, XT, or compatible
system, you will need to
reset positions 5 and 6
of
DIP switch block SW1
on your computer’smotherboard.Use Figure 4 to locate switch SW1. Reset
positions
5
and 6 of SW1
to
the ON position.
(If
you
have an XT compatible
system, refer
to
your system’suser manual
for
the correct
lactation
of SW
1.)
SW1
FIGURE
4.
With
a
ballpoint pen set SW1. positions5 and 6,
to ON.
If
SW
1
is a
slide switch,
you
will need to use
a pen or a paper clip to push
positions5 and
6
into the
ON position.
If
SW1
is a rockerswitch,use the pen
or paper clip to push
the
rockers at positions 5 and 6
dOWn
for the ON
position.
If
you have
an
IBM
AT or
compatible system: You don’t need to reset
any DIP switches in your system, since AT computers and compatible
systemsuse the SETUP file insteadofDIP switches to tell
the computerwhat
equipment is
stored in your system. Just continue on to Step 5.
Select an open expansion
slot.
Select an appropriate expansion slot for the
adapter. Any available 8bit slot
in a PC/XT or compatible, or
1
6bit slot in
a
PC/AT or compatible will do.
Remove
the
retaining screw that holds the
slot cover
in place. Slide the
slot cover out
andput
the screw aside (you will
need
it to secure the adapter).
Install the adapter. To
install the
adapter
in
the selected expansion
slot,
place the gold fingered edge connector
of
the adapter directly above an
expansion slot on the motherboard. Gently push the VGA graphic adapter
3-2