Tribe PROLIGHTS PHYRO1500UFC, Руководство пользователя

Страница: 24 / 32

PHYRO1500UFC 8
RED LED: The heater is currently warming up
FLASHING RED LED: The heater is currently warming up and requires refilliing
BLUE LED: The heater is ready
FLASHING BLUE: The heater is warmed but the fluid tank requires
2.4 REMOTE CONTROLLER OPERATION
WARNING : before removing or replacing the remote control unit disconnect the power cord.
• The DMX INPUT must not be connected.
• Via the DMX OUTPUT, it is possible connect further PHYRO1500UFC units.
The remote control (fig.3) allows to control different functions.
• Connect the remote control to the 5p connector on the rear panel of unit.
After the heating is completed, the green LED lights up to indicate that the machine is ready for use.
Operating mode: MANUAL (Manual), CONTINUOUS (Continuous), TIME CONTROLLED (Timer On/Off).
When MANUAL mode is on the haze machine can be controlled by MANUAL button, press it to emit fog
and press it again to stop fog outputs (make sure that the OUTPUT knob isn’t set to minimum).
When CONTINUOUS button turns on, the upper LED glows, the machine emits fog continuously until an
OFF green LED appears, indicating that it is now time to warm up again (make sure that the OUTPUT knob
isn’t set to minimum).
When TIMERS button turns on, the fogging duration is adjusted by turning DURATION knob, INTERVAL
which knob sets the amount of time in between every fog output, and VOLUME knob adjusts the fog
volume. DURATION and INTERVAL knobs are effective at this moment. The LED near the button lights up
yellow when the function is active (NOTE - The fog emission will be issued after a few minutes after the
activation of the function).
FUNCTION DIRECTION
INTERVAL
Setting of interval time, effective when starting the
timer function
DURATION
Setting of duration time, effective when starting the
timer function
OUTPUT
Pushing this button, the unit will issue the desided
volume (0% - 100%)
TIMER ON/OFF
Puffing timely according to the adjusted volume, du-
ration, interval, on the display
CONTINUOUS
Press the button to activate continuous emission of
fog
MANUAL
Pushing this button, the unit will issue smoke
YELLOW LED Lights up when the timer function is active
RED LED
Lights up when the remote controller is connected
to the haze machine
GREEN LED Lights up when the haze machine is ready to for use
NOTE - The length of the cable is 4,5 m
Fig.3