TriangleTube Marquis TWH180, Руководство по установке

Страница: 11 / 39

8
Unit Installation
Installations must comply with:
- All the local, state, provincial, and national
codes, laws, regulations and ordinances.
- National Fuel Gas Code, ANSI Z223.1 – The
latest version.
- National Electrical Code.
- National Standard of Canada CAN/ CSA-
B149.1-05
Check before operating the Water Heater
- Always check the connected components which
are near the water heater. The components are
below.
Water piping / Venting adapter / Gas supply pip-
ing / Electrical power / Condensate drain hose.
- Confirm area around Water Heater. Remove
any combustible materials, gasoline and other
flammable liquids. Failure to keep Water Heater
area clear and free of combustible materials,
gasoline and other flammable liquids and
vapors can result in severe personal injury,
death or substantial property damage.
- The Water Heater which has gas control system
components must be protected from any possi-
ble danger during operation and service.
- If this Water Heater replaces an existing appliance,
check and correct system problems, for example:
System leaks causing oxygen corrosion or heat
exchanger cracks from hard water deposits.
WARNING
- If the water heater was installed in a narrow space
or corner, please ensure that there is sufficient
space for service and maintenance access. For reg-
ular maintenance, there should not be any problem
accessing gas and water lines.
- The water heater must be installed on a wall that
can bear its weight.
CLEARANCES FOR SERVICE ACCESS
• The water heater must be installed on a wall that
can bear its weight.
• The Water heater can be installed on any suitable
internal wall (suitable sound proofing may be
required when installing onto a stud wall).
• For specific details of Water heater, go to Manual
page 3.
Method of positioning the water heater on a wall
• Please refer to the template before installing the
water heater.
• Attach the template exactly to the location where
you want to install the appliance.
• Drill 4 1/2” holes at the position of template bracket
which is appropriate place for installing the water
heater.
WARNING
Minimum Clearances
Required from Non-
Combustibles/Combustibles Recommended
Service Clearance
Top of Appliance
9 Inch
(228.6 mm) • 40 Inch (1016 mm)
or more
(Front of Appliance)
• 8 Inch (203 mm)
or more
(Side of Appliance)
Back of Appliance
5/8 inch
(15.9 mm)
Front of
Appliance 6 Inch
(152.4 mm)
Side of Appliance
3 Inch
(76.2 mm)
Bottom of
Appliance 12 Inch
(304.8 mm)
Marquis Manual_61515_Water Heater 7/1/15 1:58 PM Page 11