6
AVX 598USB
ENGLISH
NOTES ON USE
This is a precision electronic appliance; avoid using it in the following cases:
- Near strong heat sources, such as central heating plants or stoves.
- In very humid places such as bathrooms, swimming pools, etc.
- In very dusty places.
- In places subject to strong vibrations.
- Position the appliance in such a way that there is always enough room for free air circulation (at least 5 cm).
- Do not block the air inlets.
- If any liquid enters the appliance, unplug it immediately from the socket and take it to the nearest TREVI authorised service centre.
- Before switching on the appliance, always check that the power cable and the connection cable are properly installed.
CARE AND MAINTENANCE
Use a slightly damp soft cloth for cleaning. Do not use solvents and abrasive substances.
IMPORTANT
This appliance has been carefully built to ensure long-lasting perfect performance. However, should any inconvenience occur, please contact your
local authorised TREVI Service Centre.
TREVI follows a policy of ongoing research and development. Therefore products may have different features from those described.
DESCRIPTION OF CONNECTORS/CONTROLS
1. SD card slot
2. USB device port
3. Display
4. Unit control keypad
5. Stereo AUDIO INPUT RCA input
6. SPEAKER connector for satellite speaker connection
7. Power switch
8. FM ANT
9. 3.5 mm stereo AUDIO INPUT Jack input
10. Power cord
11. Power-on/Standby key
12. Active input selection key
13. DIMMER/SNOOZE key, display brightness adjustment / clock alarm
snooze
14. Volume up key
15. Volume down key
DESCRIPTION OF DISPLAY CONTENTS
1. Clock alarm 1 activation
2. Active RADIO input
3. Active USB port
4. Active AUX IN input
5. Active treble control
6. Active bass control
7. Wave band (FM frequency modulation)
8. MONO/STEREO reception (when ST is displayed = stereo reception)
9. Unit of measurement for frequency
10. Clock alarm 2 activation
11. Active SLEEP function
12. Radio memory/time indication
13. Frequency/volume indication
14. Unit of measurement for cut-off frequency
REMOTE CONTROL DESCRIPTION
1. Power-on/Standby key
2. MUTE key
3. DIMMER key, display brightness adjustment
4. Volume up key
5. Volume down key
6. key, treble control
7. TREBLE- key, treble control
8. BASS+ key, bass control
9. BASS- key, bass control
10. STEREO key, mono/stereo selection
11. ALARM1 key, clock alarm 1 setting
12. ALARM2 key, clock alarm 2 setting
13. SEARCH KEY, to enable the autoscan function
14. RESET key, to reset treble and bass adjustments
15.
, key, to enable the repeat function
16. USB/SD key, to switch the playback source from USB device to SD
card and vice versa
17. EQ key, to activate different preset equalisations
18.
/
key, to activate playback/pause
19.
key, playback of the previous track
20.
key, playback of the following track
21. CH+ key, to listen to the following stored radio station
22. CH- key, to listen to the previous stored radio station
23. MEMORY key, to store the tuned radio station
24. TIMESET key, time setting
25. SLEEPSET key, to enable the sleep function
26.
key, forward time/clock setting
27.
key, reverse time/clock setting
28. INPUT key, active input selection
29.
key, to go forward during manual frequency setting
30.
key, to go backward during manual frequency setting
31. ALARM key, to enable/disable the clock alarm function
32. REVIEW key, to review clock alarm settings and sleep function
REMOTE CONTROL BATTERY ACTIVATION AND REPLACEMENT
The remote control features a CR2025 battery.
To activate the remote control battery (supplied therein), remove the protective plastic tab.
To replace the battery:
1. Remove the battery compartment in the arrow direction (see figure A).
2. Replace the battery with one of the same type (CR2025).
