TRENDnet TE-350, Руководство пользователя

Страница: 49 / 60

Troubleshooting
47
4. Check the length of the NetWare print server's name. If it is
over 20 , rename the NetWare Print Server name using no
more than 20 characters.
P8: My TE-350 cannot print the jobs sent to the print queue.
S8 : The following steps may solve this problem:
1. Check if the printer attached to the TE-350 is on-line.
2. Check if your TE-350 is logged into the file server based on
procedures stated in the solution to P3.
3. Check the current status of the queue.
Run PCONSOLE and select Print Queue Information . Then
select the queue and select Current Queue Status . See if
there are three YES ’s. If not, set them to YES .
4. Check if the printer number is right.
The number 0 is for parallel port 1 of the TE-350.
5. Check to see if the TE-350 is a static queue server to the
queue.
Run
PCONSOLE and select Print Server Information. Then
select Print Server Configuration and select Queues
Serviced by Printer. Then select your desired printer and
check if the queue is on the list. If its not, insert the queue
into the list by pressing
[Insert] key and select the queue.
Then reset the TE-350 to service the new queue.
6. The queue limit for the TE-350 is 16 queues. The total
number of queues to be serviced may be over the limit. If
this is the case, remove some unused queues to keep the
number of queues within the limit.
P9: The Capture command was used to print a job, but the job was
separated into two parts.
S9 : The time out setting in Capture command may be too short. You
should increase timeout value of the Capture command. Use the
option
/TI=n of the Capture command to increase the time out
value, where n is the value of timeout.