LOCK/JIG/B
-16-
Finishing
n
The corners of the face-plate recess will need
squaring off with a sharp chisel. Alternatively
the Trend Corner Chisel Ref. C/CHISEL, can
be used to square off the rounded corners
with one tap of a hammer.
Deeper Mortise
n
Should you need to cut the mortise deeper
than the maximum depth possible with the
router cutter or router, use a relevant sized
auger bit in an electric drill to complete the
operation.
Cutting Key and Spindle Holes
n
Use a drill fitted with a suitable size drill bit to
bore a hole for the spindle and the keyhole.
n
Insert the lock body, test spindle and key
actions then screw lock into place.
n
To mark the frame to receive the striking
plate, heavily mark the end of the lock bolt
with a pencil. Close the door, open the lock
bolt as far as it will go and gently move the
door backwards and forwards.
n
The pencil marks on the frame will indicate
the position of the recess for the lock striking.
TIP
Before testing fit of the lock, engage the
lock bolt in the locked position to enable
the lock to be removed easily.
MAINTENANCE
Please use only Trend original spare parts and
accessories.
The jig has been designed to operate over
a long period of time with a minimum of
maintenance. Continual satisfactory operation
depends upon proper tool care and regular
cleaning.
Cleaning
n
Regularly clean the jig with a soft cloth.
Lubrication
n
Your jig requires no additional lubrication.
Storage
n
This jig should be stored in its packaging
after use.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing as
waste.
Packaging should be sorted for environmental-
friendly recycling.
The product and its accessories at the end of their
life should be sorted for environmental friendly
recycling.
GUARANTEE
The jig carries a manufacturers guarantee in
accordance with the conditions on the enclosed
guarantee card.
