LOCK/JIG/B
-9-
Fitting the Guide Bush
Fitting Guide Bush to T10/T11 Router
n
If using the Trend T10/T11 Router, fit a
30mm guide bush Ref.GB30/A. Make sure
the bush is correctly centred.
Fitting Guide Bush to T5 Router
n
If using the Trend T5 Router, purchase and
fit a Ref.GB30/A.
n
If using the Hinge Jig, fit the GB160 supplied
with the Hinge Jig. By using the Guide
Bush Collar supplied with the Lock Jig, the
same router set-up can be used by simply
fitting the collar between the hinge and lock
operations.
n
The guide bush collar can be stored on the
spigot fixed to the outside of the clamp bar
when not in use.
Ref. GB30/A
Ref. GB30/A
If there is any doubt about the
concentricity of cutter relevant to
the guide bush, then a sub-base
should be used in order to ensure an
accurate fit of face-plate.
Ensure guide bush collar is fitted fully
onto the guide bush with chamfer
facing the jig.
Frequently check that the guide bush
collar is seated properly on the guide
bush. Check that the collar has not
worked loose otherwise this will
affect the cut.
