TREND CDJ300, Руководство пользователя

Страница: 30 / 50

-30-
CDJ300 & CDJ600
Both parts of joint are
routed at same time.
(Drawings show CDJ300
only.)
Set Up
Fit edge guides into
holes, according to
table.
Pl
ace one piece of
workpiece into front
clamp and push tight
against edge guide,
place second piece
of workpiece in front
of first piece and
push tight against
edge guide.
Tighten front clamp
bar knobs to hold
workpiece.
Place waste piece
of workpiece under
top clamp and butt
against workpiece
already fitted. Waste
piece must be
5mm thicker than
workpiece.
Tighten top clamp
knobs.
Ensure top of both
front workpieces are
flush with packing
piece using a
square.
Fit brackets to
template comb with
countersunk holes
uppermost and with
slots to front.
Turn adjustment
stops until they are
tight against the
body.
Fit template comb
assembly onto jig.
Fit guide bush to
router according to
table.
11
10
9
8
7
6
5
2
4
3
1
F2
F1
Non-symmetrical
Even number of pins/
sockets
For
CDJ300/03
Dimensions
shown in mm.
Fit straight cutter into
router according to
table.
Adjust the height
of the cutter to suit
workpiece thickness,
this can be achieved
by drawing the
thickness of the pin
board onto the tail
board and vice versa.
12
BOX COMB TEMPLATE
Waste piece must
be 5mm thicker than
workpiece.
Comb Size Colour Hole Dia. Dia.
CDJ300/02
1/2” 19.7Øx6 Red F1 15.8 12.55
17.3Øx31 Red F2
CDJ600/02 1/2” 11.3Øx8.5 Red F1 15.8 12.55
10Øx33 Red F2
CDJ300/03
8 14Øx6 Blue F1 11.1 8.0
21Øx25 Blue F2
CDJ600/03 8 10/26Ø Blue F2 11.1 8.0