4
Install your TPS 440T and 2200T security devices
Step 5. Attach the cables
Attach the cables so that you can configure the security device from the management port and console
port.
Connect the management port
The management port connection provides Ethernet access to the device. Connect the management
port to the network to enable remote management of the device.
1. Locate the management port on the front of the unit, directly above the
MGMT
label
(
,
label
7
)
.
2. Connect one end of an Ethernet cable to the management port on the front panel.
3. Connect the other end of the Ethernet cable to your network.
Connect the console port
The console port connection provides console access to the device command line interface (CLI).
1. Locate the console port on the front of the unit, directly above the management port.
2. Connect the RJ-45 null modem cable that shipped with your product to the console port on the
front of the unit.
3. Connect the other end of the cable (standard-sized USB connector) directly to your computer.
Note:
Use the following terminal settings for the console port:
— Speed:
115200 bps
— Data bits:
8
— Parity bit:
None
— Stop Bits:
1
— Flow Control:
None
Step 6. Turn on the device
After you have reviewed all requirements for operating your product, turn on the device:
— For 440T devices, press the power switch on the back panel of the device.
— For 2200T devices, press the power button on the front panel of the device.
Step 7. Check LED indicators
When you turn on the device, the system completes a series of component checks and then displays
LED indicators to show the status of each component:
— Management port
• Link LED: Green indicates the port is linked and ready for data.
• Activity LED: Blinking amber indicates the port is passing data.
— Power
• Off: Indicates the system is off.
