Cabling Requirements
The EX Series appliance ships with the following cables:
• (2) 6 ft AC power cord, SVT, 60oC, 3x18AWG (0.824mm2)
• (1) 6 ft null modem DB9 female serial cable
You must provide any additional cables required to connect your system to the network and
other devices. Do not exceed the maximum run length of the additional cables you provide.
Rack Installation
This section explains how to install your appliance in a standard 19-inch wide rack with the
equipment provided. Because various rack units are available, the assembly procedure may
differ slightly from the following instructions. Refer to the installation instructions that came
with your rack.
Installing the Inner Rails on the Appliance
1. Starting with either rail (each works for both sides of the appliance), pull the inner
rail from the outer rail until it is fully extended.
2. Push the arrow-shaped rail-release lever on the inner rail in the direction of the
arrow and slide the inner rail out until it is detached from the outer rail.
3. Align the notches of the inner rail with the tabs on the side of the appliance.
4. While firmly pressing the inner rail against the appliance, slide it in the direction of
the tabs until you hear a click.
5. Repeat steps 1—4 with the other inner rail on the other side of the appliance.
Installing the Outer Rails on the Rack
1. Insert the front end of an outer rail (“Front Bracket” is engraved on the front end)
into the front rack column at the desired height. A metal tab will slide and lock onto
the column automatically.
2. Extend the rail until it reaches the rear rack column.
3. Insert the back end into the rack column at the same height chosen in step 1.
4. Repeat steps 1—3 with the other outer rail on the other side of the rack.
Mounting the Appliance on the Rack
1. Align the rear of the inner rails installed on the appliance with the front channels of
the outer rails installed on the rack.
EX Series
Installation
Page 15
© 2022 FireEye Security Holdings US LLC
